Manufactured with Pride
in the USA
Contact Us:
toll free 800-598-9738
outside the US 510-534-7500
fax 510-534-7550
Assembling Hyperlite is quick and easy.
First, install the bottom trusses between the lower half of the uprights. The bottom of the bottom connection should be flush to the bottom of the extrusion. Both should be on the floor with the truss 1/2” off the floor.
Next, insert the extrusion connector into the top of each upright and then slide the top half of the upright over the connector. Insure all the channels are properly aligned and tighten the screws.
Finally, install the top trusses. The top bracket has a bend at the top so the truss will be flush to the top of the upright. Tighten the wingnuts and you’re ready to install your graphics!
2
3
1
Click pdfs below for more details..
demonstration setup
Trussworks by BGB • 2100 Livingston Street • Oakland, CA 94606